Online House Design Software Forum Fnr
Select Edit in the movie control panel and press . The movie editing panel and the movie editing bar will display. Use the 4- or 4 button to select Cut Beginning or Cut End and the 4 or 4 button to specify the cut point J . To check a temporarily edited movie, select Q Play and press the FUNC. SET button. Selecting 0 Exit cancels the edit and restores the movie control panel. Select New File or Overwrite and press New File saves the edited movie under a new file name. The pre-edit data is left...
First Time Settings
1. Press the ON OFF button . 2. Use the gt or 4 button to select an item and the 4 or 4 button to change its value b . To set the daylight saving option, select the gg icon and use the 4- or 4 button to configure the setting. 3. Confirm that the correct time is displayed and press the FUNC. SET button . The date and time can also be set in the Set up menu p. 22 . A rechargeable lithium battery is built into the camera to save such settings as the date time. This battery charges when the main...
O Ovp
The setting cancels when the camera's power is turned off. The nature of CCD image sensors is such that noise in the recorded image increases at long shutter speeds. This camera, however, applies special processing to images shot at shutter speeds slower than 1.3 seconds to eliminate the noise, thereby producing high-quality images. A certain amount of processing time, however, may be required before the next image can be shot. Use the LCD monitor to confirm that the image was recorded at the...
Info Rhf
Stitch Assist can be used to shoot overlapping images that can later be merged stitched to create one panoramic image on a computer. The overlapping seams of several adjacent images can be joined into a single panoramic image. The overlapping seams of several adjacent images can be joined into a single panoramic image.
Info Uag
O Setting available. Default setting A Setting can only be selected for the first image. Default setting Shaded Area Setting is retained even when the camera power is shut 1 For Movie recording pixels and frame rates, see p. 42. 2 Cannot be selected in Long Shutter mode. 3 Default flash settings are as follows. 4 Cannot be set in the II or mode. 5 Cannot be set in the H mode. 6 In amp mode, this is set to On . It cannot be configured to the Off setting. 7 The Macro Infinity modes cannot be...