Error Codes
Error No. If there is a problem with the camera, an ^^^^^ error message will appear. Follow the onI screen instructions.
Communications between the camera and lens is
faulty, Clean the lens contacts,
Countermeasures
Countermeasures
|
No. |
Error Message & Solution |
|
01 |
Communications between the camera and lens is faulty. Clean the lens contacts. |
|
Clean the electrical contacts on the camera and lens and use a Canon lens (p.13, 16). | |
|
02 |
Card cannot be accessed. Reinsert/change card or format card with camera. |
|
Remove and insert the card again, replace the card, or format the card (p.31, 42). | |
|
04 |
Cannot save images because card is full. Replace card. |
|
Replace the card, erase unnecessary images, or format the card (p.31, 171, 42). | |
|
05 |
The built-in flash could not be raised. Turn the camera off and on again. |
|
Operate the power switch (p.27). | |
|
06 |
Sensor cleaning is not possible. Turn the camera off and on again. |
|
Operate the power switch (p.27). | |
|
10, 20, 30, 40, 50, 60, 70, 80 |
Shooting is not possible due to an error. Turn the camera off and on again or re-install the battery. |
|
Operate the power switch, remove and install the battery pack again, or use a Canon lens (p.27, 26) |
* If the error still persists, write down the error No. and contact your nearest Canon Service Center.
* If the error still persists, write down the error No. and contact your nearest Canon Service Center.
Post a comment