TermSeek Canon Repair

imn Manual Sensor Cleaning n

Dust which could not be removed by the automatic sensor cleaning can be removed manually with a blower, etc. The surface of the image sensor is extremely delicate. If the sensor needs to be cleaned directly, having it done by a Canon Service Center is recommended.

Before cleaning the sensor, detach the lens from the camera.

PHSSHIil

LCD brightness Date/Time 02/28H language© Englfr

Video system NTSC

Sensor cleaning_

Live View function settings

Select [Sensor cleaning].

• Under the [6] tab, select [Sensor cleaning], then press <©>.

Sensor cleaning

Auto clean ingrt> Enable

! Clean manually

| Select [Clean manually], t Select [Clean manually], then press

Mirror will go up, Ctean the sensor.

t Select [OK], then press <©>. In a moment, the reflex mirror will lockup and the shutter will open.

4 End the cleaning.

For the power source, using the AC Adapter Kit ACK-E8 (sold separately) is recommended.

If you use a battery, make sure it is fully recharged. If the battery grip with size-AA/LR6 batteries is attached, manual sensor cleaning will not be possible.

3HM Manual Sensor Cleaning*

® • While cleaning the sensor, never do any of the following. If the power is cut off, the shutter will close and the shutter curtains and image sensor might get damaged.

• Opening the battery compartment cover.

• Opening the card slot cover.

• The surface of the image sensor is extremely delicate. Clean the sensor with care.

• Use a plain blower without any brush attached. A brush can scratch the sensor.

• Do not insert the blower tip inside the camera beyond the lens mount. If the power is turned off, the shutter will close and the shutter curtains or reflex mirror might get damaged.

• Never use canned air or gas to clean the sensor. The blowing force can damage the sensor or the spray gas can freeze on the sensor.

• If smear that cannot be removed with a blower remains, having the sensor cleaned by a Canon Service Center is recommended.

0 0