Adjustments Possible After Disassembling The Front Panel Unit
Of the front panel units the AE unit and mirror mechanism (mirror 45° angle) require adjustment. Lubricate lever friction surfaces with Lozoid #72090, but use a small enough amount to insure^against splatter.
AE Start Position Adj.
AE Set Timing Adj. Collar
Max. Aperture Pin Height Adj. Screw (AVO)
AE Start Position Adj.
AE Set Timing Adj. Collar
Max. Aperture Pin Height Adj. Screw (AVO)
AE (AVS) Brush Setting Screw
AE Stop Gear AE Set Position AE Stop Claw
AE Eccentric Gap Adj.
AE (AVS) Brush Setting Screw
AE Stop Gear AE Set Position AE Stop Claw
AE Eccentric Gap Adj.
AE Set Position Adj.
Whe the AE unit is replaced, check AE eccentric gap, AE overcharge, and maximum aperture pin height. The other points are guaranteed by individual parts tolerances.
1. AE Set Position Adjustment
Standard: 0.4 +0.2f (with f/1.4 lens) Tools: AE Tool Standard Lens Adjustment
1) Attach a tool standard lens, and charge the front panel.
2) If the tool lens pointer does not stop within the limits adjust the eccentric.
Notes: This adjustment is not normally necessary. Close parts tolerances insure that it is usually correct.
Post a comment